The F4V2 differential expansion board connects directly to F4V2 without the need for a 40-pin ribbon cable. The board has two RJ-45 connectors. Each connector can drive a differential receiver board and the receivers can drive 4 strings of 3-wire type pixels. bbb
The new expansion boards will have two connectors. (Not shown in image) F16v2/F16V3 Expansion Board with ribbon cable Completely Assembled. This board expands a F16v2/F16V3 pixel controller to from 16 outputs to 32 outputs. (48 ports for F16v3 if two are used). 2x20 ribbon cable (20cm) is included.
CG-1500 mounting Plate for F16V2/F16V3. The plate can be used to mount one of the following configurations to CG-1500 enclosure. Controller and expansion board. Controller and power supply. Two Power supplies.
Falcon F-Amp with Ray Wu 13.5mm Pigtails The F-Amp with Ray Wu 13.5mm Pigtails include a male and female connector. Sealed epoxy for complete waterproof solution.
Falcon F-Amp with xConnect Pigtails The F-Amp with xConnect Pigtails include a male and female connector. Sealed epoxy for complete waterproof solution.
The new expansion boards has two 40-pin connectors. The Differential Expansion Board connects the the F16V2 or F16V3 via 40-pin ribbon cable. Allows up to four receivers to be connected to controller. Comes with 40-pin ribbon cable.
Falcon F-Amp The Falcon F-Amp is a line buffer designed to boost the data signal that controls 3-wire pixels. The F-Amp can be attached directly to the pixel controller or can be placed some distance away from controller. Can be used with 5 or 12V 3-wire pixels.
The F8-Distro Board is an eight port power distribution board. The board has one 30amp power input connector and eight 5A connectors. The connectors are pluggable connectors for easy connect/disconnect. LED fuse indicators (8).
The 4-String Differential SmartReceiver Board can be connected to the F16V2, F16V3 and F4V3 Differential Expansion boards as well as the popular F48 differential controller allowing 4 strings to be placed up to 250+ feet from the controllers. Note: Supports 3-wire pixels only. Dimensional Drawing
The 4-String Differential Receiver Board can be connected to the F16V2, F16V3 and F4V3 Differential Expansion boards as well as the popular F48 differential controller allowing 4 strings to be placed up to 250+ feet from the controllers. One may also be connected directly to F16V2 or F16V3. Note: Supports 3-wire pixels only. Dimensional Drawing
Expansion Boards and Receivers