Expansion Boards and Receivers
The new expansion boards has two 40-pin connectors. The Differential Expansion Board connects the the F16V2 or F16V3 via 40-pin ribbon cable. Allows up to four receivers to be connected to controller. Comes with 40-pin ribbon cable.
The F4V2 differential expansion board connects directly to F4V2 without the need for a 40-pin ribbon cable. The board has two RJ-45 connectors. Each connector can drive a differential receiver board and the receivers can drive 4 strings of 3-wire type pixels. bbb
The 4-String Differential SmartReceiver Board can be connected to the F16V2, F16V3 and F4V3 Differential Expansion boards as well as the popular F48 differential controller allowing 4 strings to be placed up to 250+ feet from the controllers. Note: Supports 3-wire pixels only. Pass-thru mode mode only (standard receiver mode) for voltage lower than...
The new expansion boards will have two connectors. (Not shown in image) F16v2/F16V3 Expansion Board with ribbon cable Completely Assembled. This board expands a F16v2/F16V3 pixel controller to from 16 outputs to 32 outputs. (48 ports for F16v3 if two are used). 2x20 ribbon cable (20cm) is included.